2M30 User Manual - Frame Grabbers

DS-24-02M30 and DS-25-02M30 User’s Manual 60
Command
Description
Syntax Parameters Description
set subtract background ssb t i Sets the value sent to the
background subtractor module
where the first parameter, t, is the
tap number either 1 or 2, or 0 for
all taps. The second parameter,
the offset value, is 10-bits wide
with a valid input of 0 to 1023.
set video mode svm i Set video mode:
0: Normal operating mode
1: Test pattern Left side
2: Test pattern Right side
3: Test pattern Both sides
4: Flip image Left side
5: Flip image Left side Test
pattern Left side
6: Flip image Left side Test
pattern Right side
7: Flip image Left side Test
pattern Both sides
8: Flip image Right side
9: Flip image Right side Test
pattern Left side
10:Flip image Right side Test
pattern Right side
11:Flip image Right side Test
pattern Both sides
12:Flip image Both sides
13:Flip image Both sides Test
pattern Left side
14:Flip image Both sides Test
pattern Right side
15:Flip image Both sides Test
pattern Both sides
voltage verify vv Check the camera voltages and
return OK or fail
warning enable disable wed i i Read enable/disable status of all
defined monitoring tasks.
Optionally, the first value selects a
monitoring task and the second
value enables/disable the selected
task. See section 3.13 Monitoring
Tasks for a list of tasks.
write output LUT wol i Store the current active output
LUT to nonvolatile memory. You
can store up to two separate
output LUTs. The parameter, i, is
the table number, either 1 to 2.
See Appendix C for more
information on using look up
tables.
DALSA 03-32-10157-02