Spyder 3 Camera User's Manual GigE Dual Line - Frame Grabbers

92
Spyder 3 GigE User Manual
System Gain (DN): 4096 4096 Digital gain settings set
with the 137Hssg command.
See section 318HA2.2 Analog
and Digital Signal
Processing Chain for
details.
GPIO Configuration Signal Mode
Input0 Disabled
Input1 Disabled
Current GPIO pinout
configuration. Refer to
section 319HA1.5
Input2 Disabled
Configuring the GPIO
Input3 Disabled
Connector for details.
Output0 High Impedance
Output1 High Impedance
Output2 High Impedance
Output3 High Impedance
Returning Camera Settings with Get Commands
You can also return individual camera settings by inserting a “get” in front of the
command that you want to query. If the command has a tap or pixel number parameter,
you must also insert the tap number or pixel number that you want to query. Refer to
320HTable 13 below for a list of available commands. To view a help screen listing the
following get commands, use the command gh.
Table 13: Get Commands
Syntax Parameters Description
get cao t Returns the analog offset for the tap indicated
t = tap selection, either 1 to 2 depending on camera
model, or 0 for all taps
get ccf x1 x2 Returns the FPN pixel coefficients for the pixel range
indicated.
x1 = Pixel start number
x2= Pixel end number
get ccp x1 x2 Returns the PRNU pixel coefficients for the pixel range
indicated.
x1 = Pixel start number
x2= Pixel end number
get css
Returns the number of line samples averaged for pixel
coefficient calculations or for output of gla command.
get dgc
Returns the current GPIO configuration.
get dpc x1 x2 Returns pixel coefficients without formatting.
get els
Returns whether the end-of-line statistics are turned off or
on.
0: Off
1: On
03-032-10158-06 DALSA