Spyder 3 Camera User's Manual GigE Dual Line - Frame Grabbers
Spyder 3 Camera User's Manual GigE Dual Line - Frame Grabbers
Spyder 3 Camera User's Manual GigE Dual Line - Frame Grabbers
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>Spyder</strong> 3 <strong>GigE</strong> User’s <strong>Manual</strong><br />
89<br />
A4.7 Returning <strong>Camera</strong> Settings<br />
Returning All <strong>Camera</strong> Settings with the <strong>Camera</strong> Parameter<br />
Screen<br />
The camera parameter (gcp) screen returns all of the camera’s current settings. The table<br />
below lists all of the gcp screen settings.<br />
To read all current camera settings, use the command:<br />
Syntax:<br />
gcp<br />
GCP Screen<br />
Description<br />
GENERAL CAMERA SETTINGS<br />
<strong>Camera</strong> Model No.: SG-10-02K80 <strong>Camera</strong> model number.<br />
<strong>Camera</strong> Serial No.: xxxxxxxxx <strong>Camera</strong> serial number.<br />
Firmware Version: xx-xx-xxxxx-xx Firmware design<br />
revision number.<br />
CCI Version: xx-xxx-xxxxx-xx CCI version number.<br />
FPGA Version: xxx.xx FPGA revision number.<br />
UART Baud Rate: 115200 Serial communication<br />
connection speed set<br />
with the 120Hsbr command.<br />
See 297HSetting Baud Rate<br />
on page 298H54 for details.<br />
<strong>Dual</strong> Scan Mode: High Sensitivity Current sensitivity<br />
mode set with the 121Hshm<br />
command. See section<br />
299HA1.1 Sensitivity Mode<br />
for details.<br />
<strong>Camera</strong> Mode: 2 taps, 12 bits Current bit depth<br />
setting set with the sdm<br />
command. Refer to<br />
section 300HA1.3 Setting the<br />
Bit Depth for details.<br />
Readout Mode: Off Current readout mode<br />
status. Set using the srm<br />
command.<br />
Exposure Mode: 7 Current exposure mode<br />
value set with the 122Hsem<br />
command. See section<br />
301HA1.4 Exposure Mode,<br />
Readout Mode, <strong>Line</strong><br />
Rate and Exposure<br />
Time for details.<br />
SYNC Frequency: 5000.00 Hz Current line rate. Value<br />
is set with the 123Hssf<br />
command. See section<br />
302HA1.4 Exposure Mode,<br />
Readout Mode, <strong>Line</strong><br />
Rate and Exposure<br />
Time for details.<br />
DALSA 03-032-10158-06