Spyder 3 Camera User's Manual GigE Dual Line - Frame Grabbers

68
Spyder 3 GigE User Manual
Purpose:
Syntax:
Syntax Elements:
Instead of manually setting the analog gain to a specific value, the
camera can determine appropriate gain values. This command
calculates and sets the analog gain according to the algorithm
determined by the first parameter.
ccg i t i
i
t
Calibration algorithm to use.
1 = This algorithm adjusts analog gain so that 8% to 13% of
tap region of interest (ROI) pixels are above the specified
target value.
2 = This algorithm adjusts analog gain so that the average
pixel value in tap’s ROI is equal to the specified target
value.
3 = This algorithm adjusts digital gain so that the average
pixel value in tap’s ROI is equal to the specified target.
4 = This algorithm adjusts the analog gain so that the peak
tap ROI pixels are adjusted to the specified target.
Tap value. Use 0 for all taps or 1 to 2 for individual tap
selection if you are using the two tap model.
i
Calculation target value in a range from 1024 to 4055DN
(12 bit LSB).
Notes: • This function requires constant light input while executing.
• If very few tap pixels are within the ROI, gain calculation
may not be optimal.
• When all taps are selected, taps outside of the ROI are set to
the average gain of the taps that are within the ROI.
• Perform analog gain algorithms before performing FPN and
PRNU calibration.
• All digital settings affect the analog gain calibration. If you
do not want the digital processing to have any effect on the
camera gain calibration, then turn off all digital settings by
sending the commands: 73Hsdo 0 0, 74Hepc 0 0, 75Hssb 0 0, and
76Hssg 0 4096
Example: ccg 2 0 3040
Related Commands:
77Hsag, 78Hssg
Setting Analog Offset
03-032-10158-06 DALSA