Spyder 3 Camera User's Manual GigE Dual Line - Frame Grabbers

116
Spyder 3 GigE User Manual
Revision
Number
Change Description
Section 2.4 Camera Connectors: Ethernet shielded cable information added.
Section 3.3 First Power Up Camera Settings: 500 Hz line rate changed to 5000
Hz. Note concerning FPN and PRNU coefficients’ factory calibration change
from 3.5 kHz line rate to 5 kHz.
Section 4: Electrical interface information, including EMC requirements and
shielded cable information, added to optical and mechanical considerations.
Section 6.3 Product Support form: Control signals section changed to reflect
GigE requirements.
Section A4.1 Ethernet test pattern revised. Ethernet test pattern only available
using the QuickCam application.
Section A4.7 Returning Camera Settings: GCP Screen updated.
Appendix B: EMC Declaration of Conformity: “Pending” stamp removed.
Products covered by the declaration and EMC requirements listed.
05 -Page 24, mechanical updated. GPIO connector corrected to female connector
from the incorrect male connector.
-Page 25, Table 5: GPIO Connector Pinout, inputs and outputs corrected to read
0 to 3, and not 1 to 4 as stated in earlier versions.
-"Preliminary" stamp removed from user manual.
06 -Revised dynamic range: Up to 1400 : 1.
-Added dark current clear information and setting the readout mode (srm)
command description to Appendix A.
-Revised camera mechanical, page 38. Ethernet connector reversed, revised
dimensions for connectors on back plate.
-Revised the gcp command results screen to include the srm command.
-ASCII reference revised to include srm command.
03-032-10158-06 DALSA