Spyder 3 Camera User's Manual GigE Dual Line - Frame Grabbers
Spyder 3 Camera User's Manual GigE Dual Line - Frame Grabbers
Spyder 3 Camera User's Manual GigE Dual Line - Frame Grabbers
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>Spyder</strong> 3 <strong>GigE</strong> User’s <strong>Manual</strong><br />
115<br />
Appendix C<br />
Revision History<br />
Revision<br />
Number<br />
Change Description<br />
00 Initial release<br />
01 Specification updates to Table 2.<br />
Updated Section 3.2 to show different methods of entering ASCII commands.<br />
Updated Section 3.4 replacing TBDs with values.<br />
Updated Section 4.1 to show inverted GPIO connector.<br />
Updated Help Screen in 334H<strong>Camera</strong> ASCII Command Help section to show latest<br />
configuration of commands.<br />
Added line rate ranges to Setting the <strong>Line</strong> Rate section.<br />
Added sgi command.<br />
Removed Vertical Binning from example gcp screen in section A4.6.<br />
02 Updated random noise, PRNU, SEE, NEE, and DC Offset specifications in<br />
Table 2.<br />
Updated step 3 in section 2.1 Installation Overview with new driver installation<br />
tool instructions.<br />
Added that Windows 2000 with SP4 installed is necessary in section 2.2 PC<br />
Requirements.<br />
In section A1.1 Sensitivity Mode, corrected values for high and low sensitivity<br />
modes.<br />
In section A1.4 Setting the Exposure Mode updated exposure mode factory<br />
setting from 2 to 7.<br />
On page 65, in Calibrating <strong>Camera</strong> Gain and in Table 10: Command Quick<br />
Reference, updated algorithm 4.<br />
In section A3 Saving and Restoring Settings, added more detail about the<br />
different sets of user settings and pixel coefficients.<br />
03 Added cpa command to section 335HA2.2 Analog and Digital Signal Processing<br />
Chain and 336H<br />
ASCII Commands: Reference<br />
Removed sgs command and updated sgi and sgo commands in section 337HA1.5<br />
Configuring the GPIO Connector and ASCII Commands: Reference.<br />
Added PRNU ECD specs to Table 2 and updated FPN global, PRNU ECD and<br />
DC offset specs.<br />
04 Section 2.1 Installation Overview: screenshots and procedure updated to reflect<br />
current version of the QuickCam GUI.<br />
Section 2.2 Equipment Recommendations: Ethernet shielded cable information<br />
added.<br />
DALSA 03-032-10158-06