Spyder 3 Camera User's Manual GigE Dual Line - Frame Grabbers

100
Spyder 3 GigE User Manual
Mnemonic Syntax Parameters Description
set baud rate sbr i Set the speed of camera serial
communication port. Baud rates: 9600,
19200, 57600, and 115200. Default:
9600.
set ccd direction scd i Sets the CCD shift direction where:
0 = Forward CCD shift direction.
1 = Reverse CCD shift direction.
2 = Externally controlled direction
control via CC3.
set data mode sdm i Sets the camera’s bit width where:
For SG-10-01K40 and SG-10-02K40
0 = 8 bits, 1 tap, 40MHz data rate
1 = 12 bits, 1 tap, 40MHz data rate
For SG-10-01K80 and SG-10-02K80
2 = 8 bits, 2 taps, 80Mhz data rate
3 = 12 bits, 2 taps, 80MHz data rate
set digital offset sdo t i Subtracts the input value from the
video signal prior to FPN correction.
t = tap selection, either 1 or 2
depending on camera model, or 0 for
all taps.
i = Offset in a range from 0 to
2048DN.
set exposure mode sem m Sets the exposure mode:
2 = Internal SYNC, internal PRIN,
programmable line rate and exposure
time using commands ssf and set
3 = External SYNC, internal PRIN,
maximum exposure time
4 = Smart EXSYNC
5 = External SYNC and PRIN
6 = External SYNC, internal PRIN,
programmable exposure time
7 = Internal programmable SYNC,
maximum exposure time. Factory
setting.
8 = Internal SYNC, internal PRIN,
programmable exposure time.
Maximum line rate for exposure time.
set exposure time set f Sets the exposure time. Refer to the
camera help screen (h command) for
allowable range.
set fpn coeff sfc x i Set the FPN coefficient.
x =pixel number within the range 1 to
sensor pixel count.
i= FPN value within the range 0 to
2047 (12-bit LSB).
03-032-10158-06 DALSA