Synchronous Generators BG 132 and BG 160

More documents

Recommendations

Info

Synchronous Generators BG 132 / BG 160 Chapter 4: 4.6 Installation of two-bearing generators (BG 132) 4.6.5.2 Hydraulic drive for BG 132 with reinforced end shield Removal prior to installation At the generator perform the removal prior to installation as described on page 56 (see Figure 18). Installation 1. Set the flange (Figure 21/1) onto the generator and fasten it using the four screws (2a). Underlay the screws with a blocking disk (2b) and apply threadlocking adhesive to the thread of the screws. 2. Plug the first part of the clutch (3) onto the generator shaft and protect it against twisting on the shaft by means of a feathered key. 3. Mount the disc (4) to the hydraulic motor (6). 4. Set the second part of the clutch (3) onto the hydraulic motor. 5. Set the hydraulic motor (6) together with the disc (4) and the second part of the clutch onto the generator. When inserting, twist the clutch a little bit until the gearing locks, if necessary. 6. Underlay the eight screws (5a) with a blocking disc (5b) and use them to fasten the disc (4) to the flange (1). 7. Place the sleeve (7) to the clutch assembly and fasten it by tightening the two screws. 60 Issue date: August 2002
Synchronous Generators BG 132 / BG 160 Chapter 4: 4.6 Installation of two-bearing generators (BG 132) 2x 7 6 8x 5a 5b 4 3 2a 2b 4x 1 Figure 21 Installation of the flange mounting for hydraulic drive (twobearing types, BG 132 with reinforced end shield) Issue date: August 2002 61
Page 1 and 2:
Synchronous Generators Series DGG,
Page 3 and 4:
Synchronous Generators BG 132 / BG
Page 5 and 6:
Page 7 and 8:
Page 9 and 10: Synchronous Generators BG 132 / BG
Page 59: Synchronous Generators BG 132 / BG
show all

Synchronous Generators BG 132 and BG 160

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?