Synchronous Generators BG 132 and BG 160
Synchronous Generators BG 132 and BG 160
Synchronous Generators BG 132 and BG 160
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>Synchronous</strong> <strong>Generators</strong> <strong>BG</strong> <strong>132</strong> / <strong>BG</strong> <strong>160</strong><br />
Chapter 4: 4.6 Installation of two-bearing generators (<strong>BG</strong> <strong>132</strong>)<br />
Installation<br />
1. Set the flange (Figure 19/1) onto the generator <strong>and</strong> fasten it using the four<br />
screws (2a). Underlay the screw head with a toothed disk (2b) <strong>and</strong> apply<br />
threadlocking adhesive to the thread of the screw.<br />
2. Plug the clutch-plate (3) onto the generator shaft <strong>and</strong> protect it against<br />
twisting on the shaft by means of a feathered key.<br />
3. Fasten the driving side of the clutch (4) to the engine <strong>and</strong> insert it into the<br />
clutch-plate. When inserting, twist the clutch a little bit until the gearing<br />
locks, if necessary.<br />
4. Fasten the flange (1) to the engine.<br />
1<br />
4x<br />
4<br />
3<br />
2a<br />
2b<br />
Figure 19 Installation for flange mounting (two-bearing types, <strong>BG</strong> <strong>132</strong><br />
with reinforced end shield)<br />
Issue date: August 2002 57