Synchronous Generators BG 132 and BG 160
Synchronous Generators BG 132 and BG 160
Synchronous Generators BG 132 and BG 160
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>Synchronous</strong> <strong>Generators</strong> <strong>BG</strong> <strong>132</strong> / <strong>BG</strong> <strong>160</strong><br />
Chapter 4: 4.5 Installation for single-bearing generators<br />
1<br />
Apply appropriate sealing<br />
depending on the engine<br />
2<br />
4x<br />
Figure 8<br />
Installation of single-bearing brush-type generators to the<br />
engine<br />
7. Insert the carbon brushes holder (Figure 9/4) correctly positioned into the<br />
generator <strong>and</strong> press it on to the collector rings on the shaft, so that the<br />
carbon brushes are pressed into the carbon brushes holder <strong>and</strong> the carbon<br />
brushes holder lies on its mounting base.<br />
8. Continue to press on the carbon brushes holder <strong>and</strong> screw in the fastening<br />
screw, but do not tighten it completely. While screwing in the fastening<br />
screw, the carbon brushes holder is automatically positioned on the<br />
mounting base.<br />
9. Check the proper seating of the carbon brushes holder <strong>and</strong> then tighten the<br />
fastening screw.<br />
10. Plug both connection cables onto the connection lugs of the carbon brushes<br />
holder according to the width of the connectors.<br />
40 Issue date: August 2002