subcon-plus-profib… - Onlinecomponents.com

SUBCON-PLUS-PROFIB…
3.3 Structure
Figure 3
Structure
3.4 Connection
Stripping
Figure 4
!
9 1
7
8
Stripping
2
34
5
The following stripping tools are recommended for fast and
easy stripping:
PSM-STRIP-FC/PROFIB (Order No. 2744623) and
QUICK-WIREFOX 6 (Order No. 1204384).
6
$
$ &
24 mm
!
6 13 5
1 Upper housing part
2 Slide switch
3 Connection block for incoming bus
4 Connection block for outgoing bus
5 Mounting screws
6 Lower housing part
7 Strain relief
8 PG connection (SUBCON-PLUS-PROFIB/PG/SC 2
only)
9 Housing screws
Cable Entry
SUBCON-PLUS-PROFIB/SC 2 and SUBCON-PLUS-
PROFIB/PG/SC 2 connectors provide the option of cable
entry from the left or from the right. Upon delivery, the
connector is assembled for cable entry from the left.
To ensure reliable operation, observe the
recommended stripping lengths shown in
Figure 4.
Connection with Cable Entry from the Left
• Strip the conductors as shown in Figure 4.
• Unscrew the housing screws and lift off the upper
housing part.
• Screw the stripped conductors in the corresponding
contacts of the connection block.
• Always connect the incoming bus cable (BUS IN) to
terminal connections 1A/1B (even at the start of the bus
system).
• Always connect the outgoing bus cable (BUS OUT) to
terminal connections 2A/2B.
When doing so, take into account the color-coding of
the connection terminals.
• To finish, mount the upper housing part and tighten the
screws. This provides the strain relief for the bus cable.
onlinecomponents.com
Figure 5
Connection with cable entry from the left
101610_en_03 PHOENIX CONTACT 4