UM EN FLX ASI SYS PRO INST - Onlinecomponents.com
UM EN FLX ASI SYS PRO INST - Onlinecomponents.com
UM EN FLX ASI SYS PRO INST - Onlinecomponents.com
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Slaves<br />
4.2.10 Setting the Address for Fieldline Extension<br />
AS-i M8 Devices<br />
Before starting up a system with an AS-Interface system for the first time, all connected<br />
devices must be assigned an operating address. By default upon delivery, all devices have<br />
the address "zero". During address assignment, only one device may be addressed with<br />
"zero".<br />
Address programming via<br />
the master<br />
Address programming<br />
using an addressing<br />
device<br />
Addressing can be performed by the master via the AS-Interface cable. All devices must be<br />
connected individually and addressed directly.<br />
For additional information about address programming, please refer to "Address<br />
Assignment" on page 7-1.<br />
There is also the option of using an addressing device for manual addressing.<br />
To manually set the address of the device, proceed as follows:<br />
• Remove the AS-i round cable from the AS-i connection (1) on the device.<br />
• Connect the addressing device (Order No. 2741338) to the AS-i connection (1) using a<br />
4-pos. unshielded cable with M12 connector.<br />
• At the touch of a button, the address of the connected slave can be read and displayed<br />
on the LCD.<br />
• The address that is returned can be modified using the two arrow buttons in order to<br />
enter the new desired address.<br />
• Press the programming button to save the device address.<br />
• Disconnect the addressing device from the device.<br />
• Connect the AS-i round cable to the AS-i connection on the device.<br />
1<br />
online<strong>com</strong>ponents.<strong>com</strong><br />
Figure 4-25<br />
O<br />
3<br />
O<br />
4<br />
7513A030<br />
Addressing and AS-i connection<br />
For additional information about addressing, please refer to the user manual:<br />
AS-Interface Addressing Device, <strong>ASI</strong> CC ADR <strong>UM</strong> E, Order No. 9013727<br />
7513_en_01 PHO<strong>EN</strong>IX CONTACT 4-23