UM EN FLX ASI SYS PRO INST - Onlinecomponents.com
UM EN FLX ASI SYS PRO INST - Onlinecomponents.com
UM EN FLX ASI SYS PRO INST - Onlinecomponents.com
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Slaves<br />
4.2.4 Mounting Fieldline Extension AS-i M8 Devices<br />
Fieldline Extension AS-i devices can be mounted directly on the machine. They can be<br />
screwed onto flat surfaces.<br />
The mounting surface must be flat to avoid strain in the housing when tightening the<br />
screws.<br />
Direct mounting The devices can be mounted directly on the mounting surface using two mounting holes (1)<br />
in Figure 4-21. The diameter of the mounting holes is 4 mm, the cylindrical sinking is 8 mm.<br />
For the drill hole spacing, please refer to the dimensional drawings in Figure 4-19 on<br />
page 4-17.<br />
Mounting on a<br />
mounting profile<br />
When mounting on a mounting profile, the mounting materials required are two screws with<br />
a diameter of 4 mm (M4) and a maximum head diameter of 7 mm and two retaining<br />
washers. The screws should have a minimum length of 30 mm.<br />
online<strong>com</strong>ponents.<strong>com</strong><br />
Figure 4-21<br />
1<br />
1<br />
DIO 4/4<br />
7513A009<br />
Front mounting of a Fieldline Extension AS-i M8 device<br />
Tighten the mounting screws with a maximum of 0.8 Nm.<br />
7513_en_01 PHO<strong>EN</strong>IX CONTACT 4-19