UM EN FLX ASI SYS PRO INST - Onlinecomponents.com

Slaves
4.1.11 Setting the Address for Fieldline Extension
AS-i M12 Devices
Before starting up a system with an AS-Interface system for the first time, all connected
devices must be assigned an operating address. By default upon delivery, all devices have
the address "zero". During address assignment, only one device may be addressed with
"zero".
Address programming via
the master
Address programming
using an addressing
device
Addressing can be performed by the master via the AS-Interface cable. All devices must be
connected individually and addressed directly.
For additional information about address programming, please refer to "Address
Assignment" on page 7-1.
There is also the option of using an addressing device for manual addressing.
To manually set the address of the device, proceed as follows:
• Remove the protective cap (1) from the female addressing connector.
• Connect the addressing device (Order No. 2741338) to the female addressing
connector using the addressing cable (Order No. 2741341).
• At the touch of a button, the address of the connected slave can be read and displayed
on the LCD.
• The address that is returned can be modified using the two arrow buttons in order to
enter the new desired address.
• Press the programming button to save the device address.
• Disconnect the addressing device from the device.
• Push the protective cap back onto the female addressing connector.
1
onlinecomponents.com
7472B006
Figure 4-15
Female addressing connector
For additional information about addressing, please refer to the user manual:
AS-Interface Addressing Device, ASI CC ADR UM E, Order No. 9013727
7513_en_01 PHOENIX CONTACT 4-13