UM EN FLX ASI SYS PRO INST - Onlinecomponents.com
UM EN FLX ASI SYS PRO INST - Onlinecomponents.com
UM EN FLX ASI SYS PRO INST - Onlinecomponents.com
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>UM</strong> <strong>EN</strong> <strong>FLX</strong> <strong>ASI</strong> <strong>SYS</strong> <strong>PRO</strong> <strong>INST</strong><br />
To reverse the orientation of the cables, proceed as follows:<br />
• Remove the cable routing aid from the device using a screwdriver (A) and turn it over<br />
(B).<br />
• Insert the cabling routing aid in the device again (C). Insert the corresponding<br />
flat-ribbon cable in the cable routing aid (D).<br />
• Close the device by pushing the electronics module back to its original position until it<br />
engages with a click (E). Then close the locking latch.<br />
AS-i<br />
AUX<br />
A<br />
B<br />
Figure 4-11<br />
Reversing the cable orientation<br />
4.1.8 Pin Assignment of the Inputs and Outputs<br />
Figure 4-12<br />
AS-i<br />
AUX<br />
AS-i<br />
AUX<br />
$ $ # ) $<br />
Pin assignment of the inputs and outputs<br />
online<strong>com</strong>ponents.<strong>com</strong><br />
C<br />
Pin<br />
Female Input Connectors<br />
IN1 IN2 IN3 IN4<br />
1 IN+1 IN+2 IN+3 IN+4<br />
2 IN2 Not used IN4 Not used<br />
3 IN-1 IN-2 IN-3 IN-4<br />
4 IN1 IN2 IN3 IN4<br />
5 Not used<br />
Pin<br />
Female Output Connectors<br />
OUT1 OUT2 OUT3 OUT4<br />
1 Not used Not used Not used Not used<br />
2 OUT2 Not used OUT4 Not used<br />
3 OUT-1 OUT-2 OUT-3 OUT-4<br />
4 OUT1 OUT2 OUT3 OUT4<br />
5 Not used<br />
AS-i<br />
AUX<br />
E<br />
D<br />
7862B004<br />
The M12 connectors are designed for a tightening torque of 0.4 Nm.<br />
4-10 PHO<strong>EN</strong>IX CONTACT 7513_en_01
Change language