UM EN FLX ASI SYS PRO INST - Onlinecomponents.com

AS-Interface Masters/Gateways
2.1.9 7-Segment Display
The 7-segment display contains different information depending on the operating state:
– During normal operation it displays a chasing light.
– In the event of a configuration or I/O error, it displays the lowest AS-i address at which
an error was detected.
– In configuration mode it displays slave addresses or error messages.
2.1.10 Removing the AS-Interface Master for Inline
(ASI MA IL UNI)
Removing the connector • If a labeling field is present, remove it.
• Remove the connector by pressing the back shaft latching (1) and levering off the
connector (2).
Removing the Inline AS-i
master from the DIN rail
Figure 2-10
Removing the connector
• Before removing the base, remove all the connectors from the AS-i master and the
connectors of the neighboring terminals (left and right).
• Release the base by pressing on the front and back snap-on mechanisms (1) and pull
it out perpendicular to the DIN rail (2).
onlinecomponents.com
2
1
1
2
63410004
1
Figure 2-11
56812005
Removing the Inline AS-i master from the DIN rail
For additional information please refer to the data sheet and the following documentation:
User manual: Configuring and Installing the AS-Interface Gateway for Inline,
UM EN ASI MA IL UNI User manual: Configuring and Installing the INTERBUS Inline
Product Range, IB IL SYS PRO UM E
7513_en_01 PHOENIX CONTACT 2-9