interbus - Onlinecomponents.com

0D5F
Code Type Description and Remedy
0D48 DEV
0D49
0D4A
0D4B
0D4C DEV
0D4D
0D4E
0D4F
0D50 DEV
0D51
0D52
0D53
The bus can be read but not started up.
– The data register of the indicated device was
interrupted.
– The data register length of the indicated
device is not identical to the length code in the
configuration frame (“ page 116).
Add_Error_Info: Error location
(Segment . Position).
An incorrect device has been installed (invalid ID
code).
Remedy: Replace the device.
Add_Error_Info: Error location
(Segment . Position).
A remote bus device has been installed in a local
bus.
Remedy: Replace the device.
Add_Error_Info: Error location
(Segment . Position).
0D54 DEV The indicated device has a protocol chip (SUPI 1),
0D55 which is not supported by the controller board
0D56 firmware.
0D57 Remedy: Replace the device with a device that
has a SUPI 3 chip.
Add_Error_Info: Error location
(Segment . Position).
0D58 DEV
0D59
0D5A
0D5B
Data transmission was interrupted at the outgoing
remote bus interface (OUT1) of the indicated
device.
Remedy: Check whether the connector is
plugged in or whether the jumper for connector
identification (RBST or LBST) is faulty.
Add_Error_Info: Error location
(Segment . Position).
onlinecomponents.com
0D5C DEV
0D5D
0D5E
0D5F
Data transmission was interrupted at the
branching bus interface (OUT2) of the indicated
device.
Remedy: See Error Code 0D58 on page 95.
Add_Error_Info: Error location
(Segment . Position).
5277CC01 95