interbus - Onlinecomponents.com

0C79
Code Type Description and Remedy
0C6C DEV
0C6D
0C6E
0C6F
0C70 DEV
0C71
0C72
0C73
0C74 DEV
0C75
0C76
0C77
0C78 RB
The indicated device executed a reset due to a
fault or insufficient voltage supply.
Remedy:
– Check the device.
– Check the voltage supply to determine
whether it conforms to the nominal value and
whether the permissible AC component was
exceeded.
– Check the power supply unit of the bus
terminal module for overload (see
corresponding data sheet).
Add_Error_Info: Error location
(Segment . Position).
The controller board tried to start up the bus
before all devices were ready for operation.
Remedy:
– Replace the device.
– Delay the call of the "Activate_Configuration"
service (0711 hex ).
– Increase the startup delay using CMD or PC
WORX software.
Add_Error_Info: Error location
(Segment . Position).
An invalid operating mode has been set on the
INTERBUS protocol chip of a device.
Remedy: Replace the device or set a valid
operating mode.
Add_Error_Info: Error location
(Segment . Position).
The data length of the indicated device is not
identical to the configuration frame when the
dynamic PCP channel is switched on
(“ page 116).
Add_Error_Info: Error location
(Segment . Position).
onlinecomponents.com
0C79 RB
The ID code of the indicated device is not identical
to the configuration frame when the dynamic PCP
channel is switched on (“ page 116).
Add_Error_Info: Error location
(Segment . Position).
5277CC01 87