interbus - Onlinecomponents.com

0C4F
Code Type Description and Remedy
0C2C RB
0C2D
0C2E
0C2F
0C30 RB
0C31
0C32
0C33
0C40 DEV
0C41
0C42
0C43
0C44 DEV
0C45
0C46
0C47
0C48 DEV
0C49
0C4A
0C4B
Missing or faulty jumper (loose contact, cold
junction) in the outgoing bus connector of the
preceding device.
Add_Error_Info: Error location
(Segment . Position).
Multiple errors in the segment of the indicated
INTERBUS device.
– Transmission errors.
– The indicated INTERBUS device has a
protocol chip, which is not supported by your
controller board firmware.
Remedy: See Error Code 0C14 on page 84 or
replace the indicated device with a device that has
a SUPI 3 chip.
Add_Error_Info: Error location
(Segment . Position).
The length code of the indicated device is not
identical to the entry in the configuration frame
(“ page 116).
Add_Error_Info: Error location
(Segment . Position).
Remedy: Change the length code or add a device
that is suited to the length code.
The ID code of the indicated device is not identical
to the entry in the configuration frame
(“ page 116).
Add_Error_Info: Error location
(Segment . Position).
The bus can be read but not started up.
– The data register of the indicated device was
interrupted.
– The data register length of the indicated
device is not identical to the length code in the
configuration frame (“ page 116).
Add_Error_Info: Error location
(Segment . Position).
onlinecomponents.com
0C4C DEV
0C4D
0C4E
0C4F
An incorrect device has been installed (invalid ID
code).
Add_Error_Info: Error location
(Segment . Position).
5277CC01 85