interbus - Onlinecomponents.com

0BF0
Code Type Description and Remedy
0BF0 BUS
0BF1 BUS
0BF2 BUS
0BF3 BUS
0BF4 BUS
The controller board reset all outputs and stopped
data transmission.
The error cause is located in a remote bus device
or a device prior to it, including all branching bus
segments.
It may have been caused by the voltage reset of a
device or a cable break. There may be a fault on
the jumper in the connector for the outgoing
remote or local bus.
Add_Error_Info: Error location
(Segment . Position).
Interrupted data transmission at the specified bus
terminal module. The connector for the branching
remote bus branch is not plugged in or the jumper
in the connector for the branching remote bus
branch is faulty.
Add_Error_Info: Error location
(Segment . Position).
Interrupted data transmission at the specified bus
terminal module. The connector for the outgoing
remote bus is not plugged in or the jumper in the
connector for the outgoing remote bus is faulty.
Add_Error_Info: Error location
(Segment . Position).
Interrupted data transmission at the specified bus
terminal module or in its local bus.
Add_Error_Info: Error location
(Segment . Position).
Transmission error (CRC error) on the data
forward path of the incoming bus interface (IN) of
the indicated device.
Remedy: Check the segment:
– Shielding of the bus cables (connectors)
– Grounding/equipotential bonding
– Faulty connectors or joints
– Voltage dips on the communications power for
remote bus devices
– Faulty fiber optic assembly
Add_Error_Info: Error location
(Segment . Position).
onlinecomponents.com
82 5277CC01