interbus - Onlinecomponents.com

0BC2
Code Type Description and Remedy
0BB4
0BB5
0BB6
The microprocessor of the indicated device
performed a reset.
Remedy: Check the device.
Add_Error_Info: Error location
(Segment . Position).
Deterioration of the transmission quality on the
data forward path at the incoming bus interface
(IN) of the indicated device.
Remedy: Check device and connection.
Add_Error_Info: Error location
(Segment . Position).
Deterioration of the transmission quality on the
data return path at the incoming bus interface (IN)
of the indicated device.
Remedy: Check device and connection.
Add_Error_Info: Error location
(Segment . Position).
0BB7 RBUS The specified device indicated a timeout and
reset all outputs, if available. The response is
identical to the response given upon a bus reset.
Add_Error_Info: Error location
(Segment . Position).
Remedy: Reduce the cycle time.
0BC0
Error message for a system coupler.
– The lower-level bus changed to the STOP
state due to a bus error.
– Voltage reset of the system coupler master
part.
Remedy: Read the exact error cause, e.g., using
the "Get_Error_ Info" service (0316 hex ), or read
the diagnostic register or diagnostics using CMD
or PC WORX software.
Add_Error_Info: Error location
(Segment . Position) of the INTERBUS device.
onlinecomponents.com
0BC2
The voltage for sensors is too low on a Loop
device.
Remedy: Reduce the number of connected
devices or reduce the extension of the ring.
Add_Error_Info: Error location
(Segment . Position).
5277CC01 79