interbus - Onlinecomponents.com

0A64
Code Type Description and Remedy
0A5A USER The "Control_Active_Configuration" service
(0713 hex ) was used in an attempt to switch on an
active device.
Add_Error_Info: Line number of the
configuration frame.
0A5B USER The configuration data transmitted to the
controller board using the
"Compare_Configuration" service (0317 hex ) does
not correspond to the configuration frame data
specified with the Frame_Reference parameter. A
device (specified by the Add_Error_Info
parameter), which is to be switched in isolation,
has been entered differently.
Add_Error_Info: Line number of the
configuration frame in which the data does not
correspond to the transmitted configuration data.
0A5C USER The "Create_Configuration" service (0710 hex )
was used in an attempt to read a local bus
configuration, which contains too many devices
(more than 63).
0A60 USER The controller board could not assign a
configuration frame (“ page 116).
Remedy: Create the configuration frame first.
0A63 USER The diagnostic status or diagnostic parameter
registers are in the output address area.
Remedy: Always place these registers in the
input address area.
Add_Error_Info: Variable_ID of the incorrectly
assigned register.
0A64 USER Address conflict between a diagnostic register
and an IN process data item.
Remedy: Using the "Set_Value" service
(0750 hex ), place the diagnostic status register and
the diagnostic parameter register in address
areas, which are not occupied by IN process data.
Add_Error_Info: Variable_ID of the register that
caused the address conflict.
onlinecomponents.com
5277CC01 73