interbus - Onlinecomponents.com

0A55
Code Type Description and Remedy
0A52 USER You tried to jumper an active device.
Remedy: First switch off the device using
"Control_Active_Configuration" (0713 hex ).
Add_Error_Info: Line number of the
configuration frame.
0A53 USER The maximum permissible number of remote bus
devices was exceeded by the user when using the
"Load_Configuration" service (0307 hex ) or when
reading the connected devices using the
"Create_Configuration" service (0710 hex ).
Remedy: Reduce the number of remote bus
devices to less than 254.
0A54 USER The maximum permissible number of I/O points
was exceeded by the user when using the
"Load_Configuration" service (0307 hex ) or when
automatically reading the connected devices
using the "Create_Configuration" service
(0710 hex ).
Remedy: Reduce the number of I/O points to the
maximum number of digital inputs and outputs for
the input and output data area. Depending on the
type of controller board, you may use up to 8192
I/O points. To obtain the exact number, refer to
the documentation for your controller board.
0A55 USER The configuration data transmitted to the
controller board using the
"Compare_Configuration" service (0317 hex ) does
not correspond to the configuration frame
specified with the Frame_Reference parameter
(“ page 116).
The device number (Segment . Position)
specified by the Add_Error_Info parameter has
been entered differently.
Remedy: The detected bus configuration does
not correspond to the expected bus configuration.
Check the list of transmitted configuration data
against the specified configuration frame.
Add_Error_Info: Line number of the
configuration frame, which does not correspond
to the transmitted configuration data.
onlinecomponents.com
5277CC01 71