interbus - Onlinecomponents.com

0954
Code Type Description and Remedy
0954 USER The controller board could not process the service
called last for the RS-232 interface, as an
incorrect value was specified for the
Parameter_Count parameter.
Remedy: Check the call of this service. The
Parameter_Count parameter must correspond to
the number of subsequent words.
0955 USER The message was not read or sent, as the
maximum permissible length of 1024 bytes for the
RS-232 interfaces was exceeded.
Remedy: If the error code occurs after a request,
the message can be read step by step. Some
services can be called several times to read large
data records. Enter an address offset for the
second call.
0956 USER The message could not be read or sent, as when
sending PCP services via the SSGI (Standard
Signal Interface), a PCP service was written to an
SSGI box with an incorrect communication
reference.
Remedy: Only write a PCP service to the SSGI
box, if the box number corresponds to the
communication reference.
0957 USER All remote PCP services of the established
connection were aborted, as the connection was
interrupted due to an abort on a communication
reference.
Remedy: Check the application program and
start it again.
0960 USER The variable ID used for the diagnostic display is
invalid.
Remedy: Set the correct variable ID.
Add_Error_Info: Invalid variable ID.
onlinecomponents.com
0970 USER When communicating with the controller board
(e.g., via IB Loader), an error occurred in the
runtime system of the controller board.
Remedy: Provide a waiting time between
services.
09D0 USER You are using a parameterization memory that is
not supported by your firmware.
Remedy: Replace the existing parameterization
memory with a suitable one.
58 5277CC01