interbus - Onlinecomponents.com

093C
Code Type Description and Remedy
093C USER The signal object was defined incorrectly.
Remedy: Define the signal object correctly. For
additional information, please refer to the services
for creating functions in the IBS SYS FW G4 UM
E Firmware Manual, Order No. 27 45 18 5.
093D USER You specified an invalid bit number in the signal
object.
Remedy: See Error Code 093C on page 56.
Add_Error_Info: Invalid bit number.
093E USER You exceeded the maximum permissible number
of write parameters.
093F USER You exceeded the maximum permissible number
of read parameters.
0940 USER You specified write parameter addresses for a
resident action.
0941 USER The controller board could not process the boot
sequence without errors due to a service call
error.
Remedy: Check the call of the service specified in
the Add_Error_Info parameter.
Add_Error_Info: Code of the service where the
error occurred.
0942 USER The controller board could not process the
"Clear_Parameterization_Memory" service
(0159 hex ), as an incorrect value was specified for
the Action_Flag parameter.
Remedy: Check the call of this service.
Add_Error_Info: Incorrect parameter value.
0943 USER The controller board could not process the
"Clear_Parameterization_Memory" service
(0159 hex ) without errors, as an incorrect address
field was specified via the Action_Flag parameter.
Remedy: Check the call of this service.
Add_Error_Info: Incorrect parameter value.
onlinecomponents.com
0944 USER The controller board could not process the
"Clear_Parameterization_Memory" service
(0159 hex ), as an undefined Action_Flag was
specified.
Remedy: Check the call of this service.
56 5277CC01