interbus - Onlinecomponents.com

092B
Code Type Description and Remedy
092B USER – A device used a communication reference,
which had not been assigned to it.
– A channel was opened via the V.24 interface
that cannot be accessed.
– The interface must not be modified while a
PCP channel is open.
092D USER The controller board rejected a PCP service, as
another PCP service is still being processed on
this communication reference.
Remedy: Wait for the PCP confirmation of the
active service, and then send the new service.
092E USER Insufficient memory available on the controller
board for initializing the standard signal interface
(SSGI), e.g., due to excessive fragmentation.
Remedy: Use the "Reset_Controller_Board"
service (0956 hex ) to execute a warm start of the
controller board, and try again.
0930 USER The controller board cannot process the
"Set_Value" service (0750 hex ), as you specified
incorrect parameters when calling the service.
Remedy: Check the call.
0931 USER The controller board could not process the service
called last. You used an undefined value for the
Variable_ID parameter.
Remedy: Check the Variable_ID.
0932 USER The communication interface on the controller
board could not enable the rights, as it is not
authorized to do so.
Remedy: Use the "Change_Exclusive_Rights"
service (014F hex ) to enable the exclusive rights
only for the MPM accessor (“ page 116), which
has these rights.
onlinecomponents.com
0933 USER The communication interface on the controller
board could not enable the rights, as a different
MPM accessor still has these rights
(“ page 116).
Remedy: Use the
"Change_Exclusive_Rights_Request" service
(014F hex ) to enable the exclusive rights only when
no other MPM accessor already has these rights.
54 5277CC01