interbus - Onlinecomponents.com

MODE - OPT
RSET Menu Item (Reset)
Only activate the reset when the application is in the
STOP state, as all outputs are set to zero.
(Otherwise the error code 1035 hex and other error
messages will be generated).
RSET Line 1: RSET (Reset)
The controller board is reset (controller board
attempts to boot) by holding down the left arrow,
down arrow, and ESCAPE key combination for
approximately 3 seconds.
LCD TEST Menu Item (Display Test)
LCD Checking all Display Segments
TEST Line 1: LCD
Line 2: TEST
Press ENTER. All segments of the display are
activated.
BUS DEV Menu Item (Bus Device) FW 4.40 or Later
Information about the generation of protocol chips in the
devices. The display refers to the active devices in the ring.
Switched off or jumpered devices are not checked.
The bus must be in the ACTIVE or RUN state.
BUS
DEV
Line 1:
Line 2:
Line 3:
Line 3:
Line 3:
BUS
DEV
TYPE 3 - all devices have a SUPI 3 or
newer chip (LPCx, OPC, etc.), which
provides improved diagnostics.
TYPE 2 - no device has one of the protocol
chips mentioned above.
MIX - there are devices present with old
and new protocol chips.
ADDR Menu Item (Setting the IP Address) FW 4.38 or
Later
Only applies to IBS 24 ETH DSC/I-T and IBS 24 RFC/486DX/
ETH-T controller boards. The procedure for setting addresses
is described in the IBS 24 ETH QS UM E Quick Start Guide,
Order No. 27 45 66 4. (In FW 4.6x or later, the IP address can
also be set using CMD.)
onlinecomponents.com
ADDR Line 1: ADDR
Line 2: IP1-4 (IP address), SUB1-4 (subnet mask),
RTR 1-4 (router address)
Line 3: Byte
5277CC01 31