interbus - Onlinecomponents.com

MODE - DIAG
DEBG Menu Item (Debug)
To simplify troubleshooting, the bus can be started up one
device at a time using the DEBG menu item.
This menu item can only be used in the READY state (see
"System Startup" on page 14).
To reach this state, start up the controller board without
parameterization memory or initiate an alarm stop using the
software.
As this menu can only be used in the READY controller state,
there will be no conflicts with the basic diagnostics.
The background illumination of this display is dependent on
this menu alone and not the basic diagnostics. If an error
occurs during startup or the execution of cycles, the
background color immediately changes from green to red. If
the error has been removed, the background color changes
back to green.
DEBG 1 Debug Is Not Possible
Line 1: DEBG (debug, troubleshooting)
Line 2: NOT NOW: The debug function can only
be executed if the controller board is in the
READY state (see above).
If DEBG is active and the state of the controller
board changes, the cycles are stopped and NOT
NOW is displayed, if necessary.
2 Connecting Devices
Line 1: DEBG (debug, troubleshooting)
Line 2: Physical bus position of the device (starting
with 1)
Switching to Devices
You can switch to the devices using the left/right
arrow keys. If you hold the arrow key down, the
display starts to scroll in increments of one. Once a
physical device number that is divisible by ten is
reached, the display scrolls in steps of ten.
You can switch to the first device using the up arrow
key.
The bus is started up to the selected device.
To start up the bus completely, press the down
arrow key.
onlinecomponents.com
5277CC01 23