interbus - Onlinecomponents.com

8040
Code Type Description and Remedy
2218* FC Runtime is too long in the task of the IEC 61131
runtime system.
Remedy: Remove error in the program.
2219 You called a function block, which does not exist
in the firmware or in the IEC 61131 runtime
system.
221A
221B
221C
221D*FC
One program in the IEC 61131 runtime system
was stopped from the program.
An unexpected breakpoint occurred.
An internal exception occurred.
String error.
Remedy: Remove error in the program.
221E* FC – Division by zero in the task of the IEC 61131
runtime system.
– Watchdog released in the task of the IEC
61131 runtime system.
– Execution time is too long.
Remedy: Remove error in the program.
2410
to
242B
26xx
6342 Bus
error
indication
Fatal error. For more detailed information, please
refer to the IBS SYS FW G4 UM E Firmware
Manual, Order No. 27 45 18 5, Revision C or later.
An exception occurred at the processor. The loworder
byte contains the vector number of the
exception.
The controller board has detected an error in the
connected bus system during INTERBUS
operation.
The bus cannot be operated any longer. The
controller board is searching for the error location.
Remedy: Read the error cause using the
"Get_Error_Info" service (0316 hex ) or use the
diagnostics in the CMD software.
onlinecomponents.com
8040 The specified device is indicating a single channel
error.
Remedy: Check the channel of the specified
device.
Add_Error_Info: Error location
(Segment . Position).
5277CC01 107