interbus - Onlinecomponents.com
interbus - Onlinecomponents.com
interbus - Onlinecomponents.com
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
1011<br />
Code Type Description and Remedy<br />
0DD8 OUT2<br />
0DD9<br />
0DDA<br />
0DDB<br />
The local bus connected to the indicated bus<br />
terminal module consists of more local bus<br />
devices than were entered in the active<br />
configuration. This may also apply to INTERBUS<br />
cables to which no device is connected.<br />
Add_Error_Info: Error location<br />
(Segment . Position).<br />
0DDC OUT2 The device connected to the branching bus<br />
0DDD interface (OUT2) of the indicated device is<br />
0DDE unknown (invalid ID code).<br />
0DDF Add_Error_Info: Error location<br />
(Segment . Position).<br />
0Fxx CTRL<br />
0FA4 CTRL<br />
0FC3 CTRL<br />
System error on the controller board (hardware or<br />
firmware error).<br />
Remedy: Reload the firmware. If the error<br />
message is still generated, a hardware fault has<br />
occurred. Replace the controller board.<br />
Checksum error on the parameterization memory.<br />
Writing the parameterization memory was<br />
aborted.<br />
Remedy: Format the parameterization memory<br />
using firmware Version ˜ 4.12.<br />
In<strong>com</strong>patibility with the PLC diagnostic block<br />
when acknowledging peripheral faults (PF)<br />
automatically using firmware Version ˆ 4.15.<br />
Remedy: Reload the firmware. If the error<br />
message is still generated, a hardware fault has<br />
occurred. Replace the controller board.<br />
1010 CTRL Firmware error on the controller board.<br />
Possible causes: There is no CPU in the rack or<br />
the CPU is in the RUN state, even though the<br />
controller board is in test mode.<br />
Remedy: Operate the controller board in a<br />
system with CPU or place the CPU in the STOP<br />
state, if the controller board is in test mode.<br />
online<strong>com</strong>ponents.<strong>com</strong><br />
1011 CTRL Hardware fault on the controller board.<br />
Remedy: Replace the controller board.<br />
5277CC01 99