Installation Manual for SMX Modules - OEM Automatic AB

Installation Manual
15.3 Fatal Error list SMX
Fatal Error Code F 1001
Fault message
Cause
Remedy
Fatal Error Code F 1003
Fault message
Cause
Remedy
Fatal Error Code F 1007
Fault message
Cause
Remedy
Fatal Error Code F 1307
Fault message
Configuration data were incorrectly loaded into the monitoring
device
Disturbed connection when loading the program into the
monitoring device.
Reload the configuration data, then switch module off/on.
Configuration data invalid for software version of module!
Module configured with incorrect software version of the
programming desktop.
Parameterize the module with the approved version of the
programming desktop, the switch the module off/on.
Device not programmed with the correct programming desktop
Program or configuration data transferred to the device using the
wrong programming desktop
Check the module design and parameterize again with a valid
programming desktop. Then switch device off/on.
Error when deleting configuration data from the Flash Memory
Fatal Error Code F 1311 / F1312
Fault message
Fatal Error Code F 1330
Fault message
Internal error – please contact the manufacturer!
Internal error – please contact the manufacturer!
Fatal Error Code F 1401 / F 1402
Fault message
Internal error – please contact the manufacturer!
Fatal Error Code F 1403 / F 1404
Fault message
Cause
Remedy
CRC of configuration data invalid!
Configuration data were incorrectly transferred
Transfer the configuration data again
HB-37350-810-01-10E-EN SMX installation manual.doc Page 75 of 75