Installation Manual for SMX Modules - OEM Automatic AB

Installation Manual
Alarm code A 3313 / A 3314
Fault message SSI sensor fault
Cause • Encoder step change SSI-value within a cycle too big
• Check encoder wiring
Remedy
• Check encoder configuration
Alarm code A 3321 / A 3322
Alarm message Plausibility fault speed sensing axis 2
The difference between the two speed sensors is higher than the
Cause
configured speed shut-down threshold
Check the theory of the distance once again using the data set in the
encoder configuration
Remedy
Check the speed sensor
Use the SCOPE function to adjust super imposable speed signals
Alarm code A 3323 / A 3324
Alarm message Plausibility fault position sensing axis 2
The difference between the two position sensors is higher than the
Cause
configured incremental shut-down threshold
Check the theory of the distance using the configured data or the
sensor setting
Check the position signal
Remedy
Are all signals correctly connected to the 9-pole encoder plug?
Check the encoder plug for correct wiring. Is bridge 1-2 connected to
the 9-pole plug (SSI absolute value encoder)
Use the SCOPE function to adjust super imposable position signals
Alarm code A 3327 / A 3328
Alarm message Plausibility fault position range axis 2
Cause
The current position is outside the configured measuring length
Check the theory of the distance using the configured data or the
sensor setting
Remedy
Check the position signal, if necessary correct the offset
Use the SCOPE function to read out the position and to set into
relation to configured values
Alarm code A 3329 / A 3330
Alarm message Plausibility fault because of faulty speed axis 2
Cause
The current speed is outside the configured maximum speed
The drive moves outside the permissible and configured speed range
Remedy
Check configuration
Use the SCOPE function to analyse the course of speed
HB-37350-810-01-10E-EN SMX installation manual.doc Page 71 of 71