Installation Manual for SMX Modules - OEM Automatic AB

Installation Manual
3.1.3 SMX12
Type designation
Device design
Design of module with the following periphery:
2 Sensor interfaces
14 digital inputs, alternatively 4 counting inputs
2 Pulse outputs
2 Relay outputs
2 LOSIDE
2 HISIDE
2 Signal outputs
1 Diagnostic and configuration interface
1 Function button
1 7-segment display
1 Status-LED
14 Status-LEDs for inputs
2 Status-LEDs for pulse outputs
2 Status-LEDs for relay outputs
2 Status-LEDs for HISIDE
1 Backplane bus interface
Characteristics of the module:
• Logic processing up to Pl e EN ISO 13849-1 or SIL 3 acc. to EN 61508
• Movement monitoring of one or two axes up to Pl e EN ISO 13849-1 or SIL 3 acc. to
EN 61508
• Speed monitoring
• RPM-monitoring
• Standstill monitoring
• Sense of rotation monitoring
• Secure incremental dimension
• Emergency Stop monitoring
• Position monitoring
• Position range monitoring
• Trend range monitoring
• Target position monitoring
• Open programmable small control system for up to 800 IL instructions
• Logic diagram oriented programming
• Pulse outputs for cross-shorting detection of digital input signals
• Counting inputs as alternatives to the digital inputs
• Safety function of external contact monitoring for connected switchgear
• Monitored relay outputs for safety relevant functions
• Monitored HISIDE/LOWSIDE outputs for safety relevant functions
• CAN-communication in connection with the SMX5x for diagnose via backplane bus
system
Mounting on top hat rail
HB-37350-810-01-10E-EN SMX installation manual.doc Page 10 of 10