ANSYS FLUENT Tutorial Guide

Chapter 1: Introduction to Using ANSYS FLUENT in ANSYS Workbench: Fluid Flow and Heat Transfer in a
Mixing Elbow
Figure 1.38 The New Results System in the Project Schematic
2. Add the solutions of each of the systems to the Results system.
a. Select the Solution cell in the first Fluid Flow analysis system (cell A5) and drag it over the Results
cell in the Results system (cell C2). This creates a transfer data connection between the two systems.
Figure 1.39 Connecting the First Fluid Flow System to the New Results System
b. Select the Solution cell in the second Fluid Flow analysis system (cell B5) and drag it over the
Results cell in the Results system (cell C2). This creates a transfer data connection between the
two systems.
Figure 1.40 Connecting the Second Fluid Flow System to the New Results System
3. Open CFD-Post to compare the results of the two fluid flow systems.
70
Release 14.0 - © SAS IP, Inc. All rights reserved. - Contains proprietary and confidential information
of ANSYS, Inc. and its subsidiaries and affiliates.