ANSYS FLUENT Tutorial Guide
ANSYS FLUENT Tutorial Guide
ANSYS FLUENT Tutorial Guide
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Figure 1.37 <strong>ANSYS</strong> Workbench Files View for the Project After Viewing the New<br />
Results in CFD-Post<br />
Note the addition of the solution and state files now associated with new duplicated system.<br />
1.4.11. Step 10: Comparing the Results of Both Systems in CFD-Post<br />
In this step, you will create a new Results system in <strong>ANSYS</strong> Workbench, use that system to compare<br />
the solutions from each of the two <strong>FLUENT</strong>-based fluid flow analysis systems in CFD-Post at the same<br />
time, then review the list of files generated by <strong>ANSYS</strong> Workbench.<br />
1. Create a Results system.<br />
In <strong>ANSYS</strong> Workbench, drag a Results system from the Component Systems section of the Toolbox<br />
and drop it into the Project Schematic, next to the fluid flow systems.<br />
Release 14.0 - © SAS IP, Inc. All rights reserved. - Contains proprietary and confidential information<br />
of <strong>ANSYS</strong>, Inc. and its subsidiaries and affiliates.<br />
Setup and Solution<br />
69