ANSYS FLUENT Tutorial Guide

More documents

Recommendations

Info

Release 14.0 - © SAS IP, Inc. All rights reserved. - Contains proprietary and confidential information of ANSYS, Inc. and its subsidiaries and affiliates. Setup and Solution 57
Chapter 1: Introduction to Using ANSYS FLUENT in ANSYS Workbench: Fluid Flow and Heat Transfer in a Mixing Elbow Figure 1.26 Velocity Distribution Along Symmetry Plane 58 e. Display filled contours of temperature on the symmetry plane (Figure 1.27 (p. 59)). i. Click the check-marked box beside the Contour 1 object under User Locations and Plots to deselect the Contour 1 object and hide the first contour display. ii. Insert a contour object. Insert → Contour This displays the Insert Contour dialog box. iii. Keep the default name of the contour (Contour 2) and click OK to close the dialog box. This displays the Details of Contour 2 view below the Outline view. iv. In the Geometry tab, select fluid from the Domains list. v. Select symmetry in the Locations list. vi. Select Temperature in the Variable list. Release 14.0 - © SAS IP, Inc. All rights reserved. - Contains proprietary and confidential information of ANSYS, Inc. and its subsidiaries and affiliates.
Page 1 and 2:
ANSYS FLUENT Tutorial Guide ANSYS,
Page 3 and 4:
Table of Contents Using This Manual
Page 5 and 6:
Using This Manual FLUENT Adjoint So
Page 7 and 8:
Using This Manual xvi The words sur
Page 9 and 10:
Chapter 1: Introduction to Using AN
Page 11 and 12:
Chapter 1: Introduction to Using AN
Page 13 and 14: Chapter 1: Introduction to Using AN
Page 63: Chapter 1: Introduction to Using AN
show all

ANSYS FLUENT Tutorial Guide

Create successful ePaper yourself

Delete template?

Save as template?