ANSYS FLUENT Tutorial Guide

More documents

Recommendations

Info

Extra You could have copied the material water-liquid (h2o < l >) from the materials database (accessed by clicking the ANSYS FLUENT Database... button). If the properties in the database are different from those you want to use, you can edit the values in the Properties group box in the Create/Edit Materials dialog box and click Change/Create to update your local copy. The original copy will not be affected. iv. Make sure that there are now two materials (water and air) defined locally by examining the Fluent Fluid Materials drop-down list. Note Both the materials will also be listed under Fluid in the Materials task page. v. Close the Create/Edit Materials dialog box. 5. Set up the cell zone conditions for the CFD simulation. Cell Zone Conditions Release 14.0 - © SAS IP, Inc. All rights reserved. - Contains proprietary and confidential information of ANSYS, Inc. and its subsidiaries and affiliates. Setup and Solution 35
Chapter 1: Introduction to Using ANSYS FLUENT in ANSYS Workbench: Fluid Flow and Heat Transfer in a Mixing Elbow 36 a. Set the cell zone conditions for the fluid zone. i. Select fluid in the Zone list in the Cell Zone Conditions task page, then click Edit... to open the Fluid dialog box. Note You can also double-click a list item in order to open the corresponding dialog box. Release 14.0 - © SAS IP, Inc. All rights reserved. - Contains proprietary and confidential information of ANSYS, Inc. and its subsidiaries and affiliates.
Page 1 and 2: ANSYS FLUENT Tutorial Guide ANSYS,
Page 3 and 4: Table of Contents Using This Manual
Page 5 and 6: Using This Manual FLUENT Adjoint So
Page 7 and 8: Using This Manual xvi The words sur
Page 9 and 10: Chapter 1: Introduction to Using AN
Page 41: Chapter 1: Introduction to Using AN

ANSYS FLUENT Tutorial Guide

Create successful ePaper yourself

Delete template?

Save as template?