Microplate Barcode Labeler User Guide - Agilent Technologies
Microplate Barcode Labeler User Guide - Agilent Technologies
Microplate Barcode Labeler User Guide - Agilent Technologies
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
50<br />
Chapter 3: Installing the VCode<br />
VCode <strong>User</strong> <strong>Guide</strong><br />
Next step<br />
After forming a connection, you can manually set the IP address through<br />
the preferences of the VCode’s firmware, as described in “Manually<br />
setting the VCode’s IP address” on page 50.<br />
Manually setting the VCode’s IP address<br />
Introduction<br />
This topic describes how to set the IP address of the VCode manually.<br />
You would do this only if you are using an Ethernet connection to the<br />
VCode and you are setting up a network that does not use a DHCP server<br />
to automatically assign IP addresses.<br />
The topic also tells you what to do if your VCode currently has a<br />
manually assigned IP address and you want to convert it to an<br />
automatically assigned address.<br />
To learn how this topic fits into the overall process of setting up an<br />
Ethernet network, see “Ethernet networking workflows” on page 39.<br />
Before you start<br />
Before you can manually set the VCode’s IP address, you must connect<br />
to the VCode following the directions in “Connecting to the VCode with<br />
HyperTerminal” on page 48.<br />
Manually assigning<br />
the IP address<br />
To manually assign the IP address:<br />
1. With the HyperTerminal screen blank, press ENTER.<br />
The diagnostics screen for the VCode’s microprocessor opens<br />
showing configuration information for it’s firmware. This diagnostics<br />
is not the same as VCode Diagnostics.