Microplate Barcode Labeler User Guide - Agilent Technologies
Microplate Barcode Labeler User Guide - Agilent Technologies
Microplate Barcode Labeler User Guide - Agilent Technologies
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
42<br />
Chapter 3: Installing the VCode<br />
VCode <strong>User</strong> <strong>Guide</strong><br />
Connecting Ethernet cables<br />
Introduction<br />
This topic describes two ways to connect Ethernet cables between a<br />
VCode and the computer.<br />
To learn how this topic fits into the overall process of setting up an<br />
Ethernet network, see “Ethernet networking workflows” on page 39.<br />
Ways to connect<br />
You can use Ethernet to connect a VCode to the computer:<br />
❑ Directly<br />
❑ Through a switch<br />
If you are setting up a stand-alone VCode, you can use either method. If<br />
you are setting up a local area network that will have other devices on it,<br />
follow only the directions for using a switch.<br />
Before you begin<br />
Before starting this procedure, and if you are setting up a new network,<br />
make sure that the IP address of the computer’s network card has<br />
already been statically assigned.<br />
Connecting directly<br />
To connect your VCode directly to the computer, will need a crossover<br />
Ethernet cable, which can be obtained from a computer supply retail<br />
outlet.<br />
To connect the VCode directly to the computer with Ethernet:<br />
1. Connect a crossover Ethernet cable to the Ethernet port of the<br />
connections panel of the Applicator.<br />
Ethernet connector<br />
00151<br />
2. Connect the other end of the cable to the Ethernet port of the<br />
computer.