Microplate Barcode Labeler User Guide - Agilent Technologies
Microplate Barcode Labeler User Guide - Agilent Technologies
Microplate Barcode Labeler User Guide - Agilent Technologies
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Chapter 3: Installing the VCode<br />
VCode <strong>User</strong> <strong>Guide</strong><br />
33<br />
Connecting the power cord<br />
Introduction<br />
This topic explains how to connect the VCode to a power source.<br />
Before you start<br />
Before you start, read the following warnings.<br />
!! DAMAGE HAZARD !! Operating the VCode at the wrong<br />
voltage can seriously damage it.<br />
!! INJURY HAZARD !! The VCode has moving parts. Keep<br />
clothing, hair and jewelry away from it at all times.<br />
Procedure<br />
To install the power cord:<br />
1. Make sure that the VCode is turned off.<br />
The on/off rocker switch on the applicator should be pressed in at<br />
the 0 symbol.<br />
2. Make sure that the printer is turned off.<br />
The on/off rocker switch on the printer should be pressed in at the 0<br />
symbol.<br />
3. Plug one end of the power cord into the AC power port at the rear of<br />
the applicator.<br />
00149<br />
Vcode<br />
power cable<br />
00149<br />
4. Plug the other end of the power cord into an appropriate, grounded<br />
electrical socket.