Microplate Barcode Labeler User Guide - Agilent Technologies
Microplate Barcode Labeler User Guide - Agilent Technologies
Microplate Barcode Labeler User Guide - Agilent Technologies
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
.<br />
Chapter 7: Using the VCode’s bar code reader<br />
VCode <strong>User</strong> <strong>Guide</strong><br />
147<br />
In practice, the fore-aft and angle adjustments may require iterations<br />
until you get good laser line coverage across labels on all sides of the<br />
plate that you want to label.<br />
Related information<br />
For more information about...<br />
Turning the VCode on or off<br />
The general process of<br />
installing a bar code reader<br />
See...<br />
“Turning the VCode on and off” on<br />
page 58<br />
“About installing the bar code<br />
reader” on page 142<br />
Testing the reader using VCode Diagnostics<br />
Introduction<br />
After installing the bar code reader, follow this topic to make sure that<br />
the reader works and that it can read labels on all sides of the plates that<br />
you plan to use.<br />
This procedure can also be used at any time to test that a bar code label<br />
design is readable before using it for a production run.<br />
Before you start<br />
This procedure assumes that PlateTag is already open and<br />
communicating with the VCode.<br />
Procedure<br />
To test the bar code reader using diagnostics:<br />
1. In the Device Selection group box of the Print Job page, select the<br />
default profile that corresponds to the type of connection cable you<br />
are using.<br />
2. Open VCode Diagnostics.<br />
3. In the I/O functions tab, click Trigger BCR.<br />
Note: If the button is unavailable, either the bar code reader was<br />
not detected during initialization, the VCode was not previously<br />
initialized, or a plate with a bar code was on the plate stage<br />
during initialization.<br />
4. The result is displayed in the Last value box above the button.