Microplate Barcode Labeler User Guide - Agilent Technologies
Microplate Barcode Labeler User Guide - Agilent Technologies
Microplate Barcode Labeler User Guide - Agilent Technologies
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
138<br />
Chapter 6: Running a print job<br />
VCode <strong>User</strong> <strong>Guide</strong><br />
Test printing with a print job in sticky mode<br />
Introduction<br />
There are several ways to perform test prints using VCode Diagnostics,<br />
but none of these methods use schemas. You can use a function called<br />
“sticky mode” to conveniently test the schemas that you intend to use in<br />
a print job, as well as the function of the VCode.<br />
About sticky mode<br />
In sticky mode you press the green button once to start labelling and<br />
again to stop. The VCode will repeatedly label the same plate.<br />
Procedure<br />
To set up sticky mode:<br />
1. Set up a print job that conforms to your test requirements.<br />
2. Select Edit > Preferences.<br />
3. Click the Jobs tab.<br />
4. Select Enable sticky mode.<br />
5. Click OK.<br />
6. Press the green button to start the test.<br />
7. Press the green button to stop the test.<br />
Related information<br />
For more information about...<br />
Performing a test print<br />
See...<br />
“About test printing and applying” on<br />
page 99