Microplate Barcode Labeler User Guide - Agilent Technologies
Microplate Barcode Labeler User Guide - Agilent Technologies
Microplate Barcode Labeler User Guide - Agilent Technologies
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
126<br />
Chapter 6: Running a print job<br />
VCode <strong>User</strong> <strong>Guide</strong><br />
Deleting a schema<br />
You can delete schemas that you no longer want to use.<br />
To delete a schema:<br />
1. In PlateTag, click the Schemas tab at the bottom of the page.<br />
2. Click Delete schema.<br />
Related information<br />
For more information about...<br />
See...<br />
Configuring a schema “Configuring a schema” on page 126<br />
The drive location of saved<br />
schemas<br />
“Setting the locations of stored files” on<br />
page 109.<br />
Starting PlateTag “Starting PlateTag” on page 58<br />
Configuring a schema<br />
Introduction<br />
This topic describes how to configure a schema, which you must do<br />
before using it in a print job. When you configure a schema, you define<br />
each field that will be printed on a label, along with the label format and<br />
the vertical position of the plate stage.<br />
About defining fields<br />
Only define the fields that you want to print on your bar code label. If<br />
you do not want to define a field, leave the default data source in the<br />
Type column.<br />
Before you start<br />
Before configuring a schema, you must have done all of the following:<br />
❑ Planned where the label data will come from.<br />
❑ Set up either:<br />
A data source.<br />
One or more counters, constants or clones.<br />
❑ Established which fields are used in the label format that you intend<br />
to use in the schema.<br />
!! IMPORTANT !! The information that is printed on a label<br />
depends on the fields that you configure in the schema as well<br />
as the fields used in the bar code label format. If a field is not<br />
used in the label format, it will not be printed even if you<br />
configure it in the schema.