Sam4s 650 pgm/user - SALOP CASH REGISTERS WEBSITE

PROGRAMMING A TAX TABLE
In some cases, a tax that is entered as a percentage does not follow exactly the tax charts that
apply in your area (even if the tax chart is based on a percentage). In these cases, we
recommend that you enter your tax using tax table programming. This method will match tax
collection exactly to the break points of your tax table.
Before programming, obtain a copy of the tax table you wish to program. You will need the
printed tax table if you wish to determine the break point entries yourself. The "
Tax Table Programming Example - Illinois 6% Tax Table" on page 57 is used as an example
in the steps that follow.
Note: You can enter up to 75 break points.
Turn the control lock to the PGM position.
From the PROGRAM MODE menu, press 2 to view the TAX PROG. screen:
TAX PROG.
TAX NUMBER (1-4) 1
DESC : TAX1
TAX TYPE (0-2) 1
0 : ADD-ON
1 : TAX TABLE
2 : VAT
When the arrow is pointed at the TAX NUMBER field, enter the number of the
tax you wish to program. (There are four taxes available, enter 1, 2, 3, or 4.)
The arrow will move to the TAX TYPE field.
Enter 1 for an TAX TABLE programming. The appropriate TAX #
PROGRAMMING screen displays:
TAX #1 PROGRAMMING
FIRST TAX AMOUNT
0.01
NON-TAXable AMOUNT
0.10
# OF NON-REPEAT
BREAK 5
# OF REPEAT BRK 3
Use the table below as a guide in filling the fields on this screen. After
completing these entries, your screen should look like the screen that follows.
Field
Description
YCR 56 ER-650