Sam4s 650 pgm/user - SALOP CASH REGISTERS WEBSITE

FUNCTION KEYS
Although none of the functions necessary for check tracking operations appear on the default
keyboard, any or all of the following functions can be located on the keyboard:
CHECK #
GUEST
P/BAL
SERVICE
TABLE
PRINT CHECK
TIP
The CHECK # key is used to begin a new, or access an existing
balance (hard check) or itemized bill (soft check.)
Check track numbers that are entered manually may be set at a fixed
length of one to nine digits. Check track numbers assigned
automatically will begin with #1.
Existing checks are accessed by entering the check track number
and pressing the CHECK# key. In a drive thru system, simply
pressing the PBAL key will recall the oldest open balance (lowest
check track #).
Use to enter the count of guests served as part of a guest check. The
entry of a guest count can be enforced when opening a guest check, or
for all transactions.
Use to enter the amount of an outstanding balance. The P/BAL key
will take the recall function if the drive thru feature is enabled in
CHECK # key programming.
Use to temporarily finalize Previous Balance or check tracking
transactions.
You can enforce the entry of a table number for guest check
transactions, or for all transactions. If you are tracking guest check
balances, the balance can be recalled either by entering the check
number or the table number.
Use to print a guest check. The check can be printed on an optional
(RS-232C) printer, or can be printer on the receipt printer. The PRINT
CHECK key can be set to automatically service the check.
The TIP key allows a gratuity to be added to a guest check before
payment. The tip amount is deducted from the Cash-in-Drawer
amount for the Clerk/Cashier closing the guest check.
The TIP key may be programmed as either a percentage or amount.
If programmed as a percentage, tax programming defines whether
the percentage is calculated on the net (taxable = no) amount, or the
amount after taxes.
See "Function Key Assignment" to place the functions necessary for your
application. See "Function Key Programming" to set the options for each function.
YCR 201 ER-650