Crocus SHDSL Repeater 2P - Route 66 Communications

Crocus SHDSL Repeater 2P Chapter 4 43
User manual
Monitor interface
4.6 Fault and maintenance management (FMM)
This sub-menu groups all the commands for fault and maintenance monitoring. When entering this submenu,
the following is displayed:
Fault and maintenance management activated
Enter to return to MAIN, or for HELP information
The fault and maintenance commands are the following:
STATUS
This command displays the actual status of the Crocus SHDSL Repeater 2P.
RR_03_FMM> STATUS
----------------------------------------------------------------------
Local System Status N/C Side
----------------------------------------------------------------------
LOSD : 1 1
SEGA : 1 1
PS : 1 1
SEGD : 1 1
Tx power : 07.5 07.5 dBm
Rx gain : 13.9 13.9 dB
Loop attn.: 00.0 00.0 dB
Bitrate : 2064 2064 kBit/s
----------------------------------------------------------------------
RR_03_FMM>
Definitions:
LOSD
(Loss of Signal)
SEGA
(Segment Anomaly)
PS
(Power Status)
SEGD
(Segment Defect)
Tx power
Rx gain
Loop attn.
Bitrate
Indicates the loss of signal from the application interface.
• Loss of Signal = 0
• Normal = 1
Indicates a CRC error on the incoming SHDSL frame. A segment anomaly indicates
that a regenerator operating on a segment has received corrupted data
and therefore the regenerated data is unreliable.
• CRC Error = 0
• Normal = 1
Normal = 1
A segment defect indicates that a regenerator operating on a segment has lost
SHDSL synchronisation and therefore the regenerated data is unreliable.
• Segment Defect = 0
• Normal = 1
Local transmit power in dBm.
Local receiver gain in dB.
Estimate of the loop attenuation in dB of the actual connection.
Bitrate of the actual connection.