Crocus SHDSL Repeater 2P - Route 66 Communications
Crocus SHDSL Repeater 2P - Route 66 Communications
Crocus SHDSL Repeater 2P - Route 66 Communications
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
22 <strong>Crocus</strong> <strong>SHDSL</strong> <strong>Repeater</strong> <strong>2P</strong> Chapter 2<br />
User manual<br />
Installing and connecting the <strong>Crocus</strong> <strong>SHDSL</strong> <strong>Repeater</strong> <strong>2P</strong><br />
Wiring the male IP67 power plug<br />
To attach the male IP67 power plug to the cable, proceed as follows:<br />
Step<br />
Action<br />
1 Unscrew the nut (6).<br />
2 Remove the IP67 plate (3).<br />
3 Unscrew the connector housing (2) from connector block (1).<br />
4 Slide the cable through the nut (6), the pressure ring (5), the wire transit (4) and the connector<br />
housing (2).<br />
5 Wire the cable to the connector block (1). Refer to 5.8 - Power connector lay-out on<br />
page 54.<br />
6 Screw the connector housing (2) and the connector block (1) together.<br />
7 If the diameter of the cable is not big enough to seal the opening of the wire transit (4)<br />
air- and watertight, then use the high temperature silicone paste (delivered with the outdoor<br />
<strong>Crocus</strong> <strong>SHDSL</strong> <strong>Repeater</strong> <strong>2P</strong>) to glue the cable into the wire transit (4). This will<br />
ensure the IP67 quality. Refer to step 8 of the procedure Wiring the male IP67 signal plug<br />
on page 20.<br />
8 Tighten the nut (6). This nut ensures the IP67 quality.<br />
9 Now plug the male IP67 power plug you just wired into the female IP67 power connector.<br />
Refer to 2.6.1 - Parts of the outdoor <strong>Crocus</strong> <strong>SHDSL</strong> <strong>Repeater</strong> <strong>2P</strong> on page 16.