Crocus SHDSL Repeater 2P - Route 66 Communications

12 Crocus SHDSL Repeater 2P Chapter 2
User manual
Installing and connecting the Crocus SHDSL Repeater 2P
2.3 Selecting a site
Indoor Crocus SHDSL Repeater 2P
Indoor use only! Install the unit in an area free of extreme temperatures, humidity, shock and vibration.
Position it so that you can easily see and access the front panel. Leave enough clearance at the back
for cables and wires. Position the unit within the correct distances for the different accesses and, if powered
locally, within 2m of a power outlet.
Outdoor Crocus SHDSL Repeater 2P
Outdoor use is allowed. Protection against moisture, vibration and impact.
2.4 Connection precautions
ESD warning
The circuit boards are sensitive to electrostatic discharges (ESD) and should be handled with care. It is
advisable to ensure an optimal electrical contact between yourself, the working area and a safety ground
before touching any circuit board. Take special care not to touch any component or connector on the
circuit board.
EMC compliant installation
The Telindus access products are fully EMC compliant. To ensure compliance with EMC directive 89/
336/EEC, shielded cables or ferrite beads have to be used.
The connectors of the Crocus SHDSL Repeater 2P should only be connected to the following circuit
types:
Connector name Connector label Connector type Circuit type
monitor connector MONITOR subD-9 SELV
SHDSL line connector xDSL RJ45 TNV-1 1 /
TNV-3 2
1. without remote powering
2. with remote powering
• SELV (Safety Extra Low Voltage): local connection (e.g. PC to Crocus SHDSL Repeater 2P) or
leased line inside the building.
• TNV-1 (Telecom Network Voltage): leased line outside the building.
• TNV-2: PSTN from PABX inside the building.
• TNV-3: PSTN from operator PABX outside the building.