PC Control / Profi Control 645-12M Instruction Manual pdf - Kuhnke
PC Control / Profi Control 645-12M Instruction Manual pdf - Kuhnke
PC Control / Profi Control 645-12M Instruction Manual pdf - Kuhnke
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
4.4. PLC working method<br />
<strong>PC</strong> <strong>Control</strong> <strong>645</strong>-<strong>12M</strong> used as PLC<br />
The microprocessor for the user program receives its instructions<br />
from two memory sources:<br />
-> monitor program memory<br />
-> user program memory<br />
The monitor program contains all system features of the<br />
controller <strong>PC</strong> <strong>Control</strong> <strong>645</strong>-<strong>12M</strong>. It is delivered with the controller.<br />
The user program is written by the user based on the functionality<br />
of the KUBES programming software.<br />
As it is only practical to run <strong>PC</strong> <strong>Control</strong> <strong>645</strong>-<strong>12M</strong> when<br />
networking with other devices, it has to be configured as a<br />
station in a PROFIBUS network. This configuration task is<br />
taken care of by VEBES, the network operating software.<br />
In the following chapters you will find all information required<br />
for writing user programs for <strong>PC</strong> <strong>Control</strong> <strong>645</strong>-<strong>12M</strong>.<br />
This manual does not describe how to configure a network<br />
or how to write the user program. For the relevant information<br />
please refer to the manuals listed below:<br />
-- E 327 GB Beginner's <strong>Manual</strong> KUBES<br />
-- E 315 GB Beginner's <strong>Manual</strong> VEBES<br />
as well as to the appropriate online help systems<br />
and<br />
-- E 417 GB Programming <strong>Manual</strong> for <strong>Kuhnke</strong> PLCs<br />
4 - 15
Change language