27.03.2014 Views

CDN Price Guide - Krug

CDN Price Guide - Krug

CDN Price Guide - Krug

SHOW MORE
SHOW LESS

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

INSTALLATION<br />

INSTALLATION<br />

Drawer Removal<br />

To remove pedestal drawers, open to the extended position. Press down on the right side nylon release lever<br />

and lift up on left side release lever at the same time. Pull the drawer out of the case.<br />

Bookcase or Hutch Door Adjustment<br />

Hinges on all hutch and bookcase doors are designed to be adjusted for depth, horizontal and vertical<br />

adjustment by means of screws into the hinge mounting plates. To remove a door, squeeze the release clip<br />

and pull out the door, disconnecting the hinges.<br />

Glide Adjustment<br />

Raise one corner of the unit at a time and adjust the glide to the desired height by turning the glide in the<br />

hole. Make sure unit is level after adjusting the glides. Please note that the maximum adjustment range of<br />

the glides is 3/4′′. When moving units after glides have been inserted, dial the glides to the lowest position<br />

to prevent damage to the case.<br />

Connecting Worksurfaces<br />

It is important that the main units (desk, credenza) to which the linking unit or return is being attached be<br />

in their final position and leveled.<br />

Locate the linking brackets under the main unit tops, per the installation instruction sheet.<br />

Hutch Installation<br />

Before installing the hutch, ensure that the worksurface has been placed in the final position and leveled.<br />

The worksurface should then be moved out a sufficient distance to allow access to the back. It is<br />

recommended that the minimum amount of movement be used with the leveling glides extended to prevent<br />

damage to the glides.<br />

The hutch comes with self-adhesive foam strips that must be applied to the bottom edge prior to placing the<br />

hutch on the credenza. The foam is best applied with the hutch lying on its back. Do not leave any gaps in<br />

the foam strip. This will prevent scratches to the credenza top while placing the hutch.<br />

Place the hutch on the worksurface making sure the hutch back panel is flush with the back edge of the<br />

case below. Try to minimize any movement of the hutch to prevent scratching. Use of a blanket on the front<br />

portion of the credenza is recommended.<br />

EFFECTIVE MARCH 1, 2008 A PRICE INCREASE OF 8.15% WILL APPLY TO ALL PRODUCTS IN THIS PRICE LIST<br />

28 | CANADA VIRTU

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!